"Geoff, it has occurred to me that if you remove the bolt through the lower suspension mount, you should be able to swing the whole wheel and hub assembly outwards, hinging on the shock upper mount and therefore releasing the U/J joint from the…"
Qpod Club - be part of the fun!
Alan's Discussions
Funtech 350 for sale.
Started this discussion. Last reply by Alan Nov 8, 2017. 5 Replies 1 Like
Funtech 350 for sale
Started this discussion. Last reply by Alan Jun 12, 2015. 11 Replies 0 Likes
Gifts Received
Alan has not received any gifts yet
Alan's Page
Latest Activity
"Hi Geoff.
You have a choice to either remove the Hub as an assembly, or to remove the drive shaft through the brake hub leaving the hub in place along with the brake still in place.
From memory the following needs to be done.
Disconnect the…"
"Hi Chad.
There aren't any official manuals that I know of. There are wiring diagrams kicking around on the forum and on facebook. Otherwise its follow the forums and do as you are doing now - ask! Someone may well be…"
"Hi Wayne
Can't help with the tracking I'm afraid, but you need to fit a tow lock to your gear shift!
I made mine with a hinge with a slot cut out.
Regards Alan"
"Hi Rod.
If the gears select ok when the engine is off, then its probably caused by clutch drag. This could be due to the tick over being set too high. Reduce the idle to the minimum speed possible without stalling. Adjuster…"
"Hi Rod.
Yes the gearbox is totally separate from the engine oil.
From memory the engine has a drain in the sump. Fill with 20/50 oil through he dipstick hole.
The gear box has a drain hole on the off side of the gear box. The filler…"
Profile Information
- About Me:
- Suffolk based bright yellow Funtech 350 owner, usually used on holidays towed behind a six wheeler homebuilt motorcaravan. Into Bikes cars - anything with wheels really! We go to lots of Rallies / shows / steam fairs etc and a few of the micro ar rallies too.
- What model of Qpod do you have?
- Fun
- Do you have a motorhome?
- Yes
Alan's Photos
Comment Wall (7 comments)
- At 9:44 on February 17, 2018,
Wayne said… Hi Alan
yes I found the thread and the jobs done, it chewed up the cover a bit so will have make some modifications but other than that all good. Next job is that transmission lock!
thanks again Wayne
- At 13:15 on February 16, 2018, Wayne said…
Hi Alan
when you changed the drive belt did you take the NSR wheel of for access
thanks wayne
someware in a field in Cornwall I think
- At 11:34 on October 13, 2017,
Bob Townsend said…
Hello Alan Did you sell your yelow qpod?, if not i am interested.
best wishes Bob
- At 22:28 on February 17, 2009,
GAVIN KAY said…
- thanks 4 the info alan my qpod has only done 1070 km witch is only 664 miles thats from new so i cant see it been the belt but will give it a try and a full service cos been stood a few years cheers
- At 22:03 on February 17, 2009,
- Hello alan you have an x reg pod i c in your pics who did you get ins with and could you tell me the top speed of ur pod mine only doze 34 mph flat out is this right 4 the early ones and can you make it go any faster as i live in busy area could do with 45 50 mph if pos any info would be greatfull cheers
- At 21:15 on January 16, 2009, barry singer said…
- Hi Alan NO it is a 338cc sport K.ev just fitted a gearbox he said came from a 50cc q-pod that he broke for spares as it would not sell he said mine had a crack in casing, I don't know if it was damaged when belt burnt out,,or when Secma fixed it,they didn't want me to see them repair it, but when i looked in next day i saw pod hanging vertically on a chain or rope from a ceiling beam rather worrying!, they were very annoyed i had come in and seen this and ushered me outside pronto.they brought it out 1 hour later charged me400euro new belt and fitted hand start kit . Next day found it was snatchy and jerky also jumped out of gear we were now in Boulogne seeing oil under gearbox decided to let kevin sort it so towed it to him. regards Barry Singer.
- At 18:38 on October 8, 2008,
Alec said…
- Hi Alan, glad to see you join Qpod Club. Don't forget to introduce yourself in the forum :)
Notes
Read the Rules
Created by Alec Oct 6, 2008 at 9:39am. Last updated by Alec Oct 6, 2008.
Introduce yourself!
Created by Alec Oct 5, 2008 at 1:36pm. Last updated by Alec Oct 5, 2008.
Secma & Qpod spotlight
Qpod Sport by John Nichols
If you would like your Qpod to be featured, please email it to: admin (at) qpodclub.com
© 2019 Created by Alec.
Powered by
