John Elliott's Page

"When I contacted DVLA regards  road fund licence for the pod (340cc) ,the person I spoke to agreed that the taxation class did not seem correct as the engine was so small a capacity. It was suggested that if i could get the manufactures …"

"Hi. This is a thread from 2009. the Petition is long since expired.   Alex."

"I to would be happy to sign the petition when it gets going :)"

"Hi and Thanx. I wholeheartedly support the quest and campaign for lower tax on the QPOD. It is rediculous as it stands. I would certainly add my name to any partition to lobby the government on this issue. Everyone to whom I have spoken say the same…"

"Thank you for your advice. Yes I have read the qpod forum articles but remain puzzled as some refer to an alloy hub. Mine is a steel hub to which is welded the suspension arm "ears". I also downloaded the pages of parts diagrams which will…"

"My pod (2005) has the two bearing hub. The first sett of bearings failed within the 12 month warranty and were replaced F.O.C. However since then I have been careful not to tow above 55mph yet have had a further set of replacement bearings. The rear…"

"Ok - i'm gona dump this through a Spell Chequre and put the petition up. It will probably take a few days for the petition to appear."

"Alex said:Hi After an hour of trying to find the exact wording required to petition parlement I stumbled across this rather helpfull fact sheet: http://www.parliament.uk/documents/upload/p07.pdf It appears that the requisits have changed and any…"