Qpod Club - be part of the fun!
I have great difficulty in getting the Qpod sport out of reverse gear. Any suggestions. Rod
Add a Comment
Join Secma Qpod Club
If the gears select ok when the engine is off, then its probably caused by clutch drag. This could be due to the tick over being set too high. Reduce the idle to the minimum speed possible without stalling. Adjuster is a screw on the throttle linkage - carb end).
If the idle speed is ok, you could adjust the gearbox variator assembly. If you look at the gearbox pully, towards the centre, there should be a small bolt with a lock nut. Loosen the lock nut and make small adjustments to the screw. (I think in this case screw the adjuster in). Recheck for smoother selection. This action opens or closes the variator pulley slightly, reducing the grip on the belt.
Other than that, could the selector linkage be maladjusted?
Welcome toSecma Qpod Club
Sign Upor Sign In
Created by Alec Oct 6, 2008 at 9:39am. Last updated by Alec Oct 6, 2008.
Created by Alec Oct 5, 2008 at 1:36pm. Last updated by Alec Oct 5, 2008.
Secma & Qpod spotlight
Qpod Sport by John Nichols
If you would like your Qpod to be featured, please email it to: admin (at) qpodclub.com
© 2018 Created by Alec.
Report an Issue |
Terms of Service
Please check your browser settings or contact your system administrator.